LK201 C200H PDF

Product category: PLCs – Omron – C – Omron CH-LK (CHLK) This unit is fully tested prior to. Q: Can CH-LKV1 Host Link Unit be used with CS1-series Programmable Controllers?. CH Units that use the CPU bus, SYSMAC LINK Unit, CHW-SLK23/24 ( wired) CHW-SLK13/14 (optical). Controller Link Unit, CHW-CLK21 (wired ).

Author: Malabei Mukasa
Country: Albania
Language: English (Spanish)
Genre: Marketing
Published (Last): 11 October 2009
Pages: 107
PDF File Size: 2.98 Mb
ePub File Size: 16.53 Mb
ISBN: 328-6-99810-201-2
Downloads: 68963
Price: Free* [*Free Regsitration Required]
Uploader: Kazrajind

Edited 16 Nov by sokhanh.

Omron CH-LK (CHLK) – Axdos AB | PLCSWEDEN | Automation Spare Parts

Sign In Sign Up. Be careful what you plug into it. Sign up for a new account in our community. This may or may not be an issue if they are mismatched What is the part number of your back plane?

Help me with c200h-lk201

I will check the cable one more time! Thank you for your explaination, I have tried with pin 3 on the back OFF but still cannot conect.

After c020h this I found conflicting information in the manuals. Share this post Link to post Share lk20 other sites. If this is a 1 to 1 connection between the PC and the PLC then this is probably correct but not guaranteed. One says not to use those slots, the other says it’s OK but you will lose some functionality on the peripheral port.

  GAMPOPA JEWEL ORNAMENT PDF

I did notice that both of his modules are in the restricted slots. It is a pre-Alpha series.

Omron CCNEU Programming Cable, For Use With CH-LK PLC, 6 ft Buy from Cross

Try to put il elsewhere. Posted lk21 Nov Posted 15 Nov edited. I have blown internal circuit board fuses on some of the older CH’s by trying to use that port. On the CPU, led “run” is green. Last week, the cpu couldn’t power on, so I have replaced with a new CPU.

It’s on page 9 in the manual. Edited 15 Nov by sokhanh.

Omron SYSMAC C200h-lk201 Host Link Unit C200HLK201

As far as using the peripheral port Posted 21 Nov Posted 15 Nov Maybe the backplane is bad. All the configuration is done with the LK switches.

I have tried with an ch-lkv1 but everything is the same. The long port at the bottom is for a 3G2A6-LK Register a new account.

Started by sokhanh13 Nov C Series Host Link Units. Create an account or sign in to comment You need to be a member in order to leave a comment Create an account Sign up for a new account in our community. In any case, look here: I have replaced ch-lkv1 by ch-lk and everything is the same.

  ANNONA MURICATA ANTICANCER PDF

Sign in Already have an account? PCMRthat Data will kl201 to be reentered into the appropriate locations. One of the other old school guys will have to answer this one. Maybe the PLC power supply is bad. I also tried with this cable LK Coputer You should verify the cable. Posted 13 Nov edited.